Specifications
42
any preset to a MIDI number including using a preset at multiple locations. Using
an empty preset as a bypass enables you to select no effect eliminating the need
to bypass the unit from the front panel and then continuing on with an effect
preset next in the chain. NOTE: If your Mix is set for only 100% EFX, no signal
will pass through the MULTIVERB ALPHA 2.0.
-Make sure you are in EDIT Mode. (Press EDIT button if not)
-Press the MIDI button.
-Press the Value button, use the Encoder to change the display to:
MIDI PROG= 0 > MIDI PROG= 0
PRESET= 1_ > PRESET= 60_
-change between the upper and lower lines, changing the values as needed.
*MIDI program #'s will be 0 thru 9.
*follow the procedure in Example 1 if you're stuck!
EXAMPLE 4
Programming the REMOTE jack for Incrementing Programs
Program the REMOTE 1 jack on the rear panel so you may use a footswitch to
increment through a desired set of presets, operate as a normal bypass jack, or
trigger the Sampler. Remember, you may only increment up when using a footswitch
and the sequence cycles through to the beginning.
-Make sure you are in EDIT Mode. (press EDIT button if not)
-Press the UTILITY button. Change the display to read [REMOTE SWITCH 1] in the
top half and [= BYPASS ON/OFF] in the bottom half.
-Press the Value button.
-Use the ENCODER to change the number to 9.
*You have just programmed the MULTIVERB ALPHA 2.0 to sequence through the ten
presets set in Example 3 when using a momentary footswitch plugged into the
REMOTE 1 jack.
REMOTE SWITCH 1
= INCR PROGS 9
NOTE:
To change this to decrement presets, program the REMOTE 2 jack for
decrement following the above example.
REMOTE SWITCH 2
= DECR PROGS 9
EXAMPLE 5
Adding
P
erformance
M
IDI to an existing preset.
In this example we are going to add
PM
to preset 79, NEW BLUES GTR. The effect
parameter we will control is: CHO:WIDTH, the width of the chorus. The intended
controller will be MC 4, Foot Controller. Now when the MIDI controller is used,
the width control will change from 50% to 100%.
-Recall preset 79.