Specifications

41
When used with a keyboard or other device which sends MIDI PROGRAM CHANGE
messages, MPT editing is simplified. We will edit the MPT for MIDI numbers 2 and
3, to recall presets 96 and 1. Once again it is assumed the MULTIVERB ALPHA 2.0
has not had its MPT edited.
The keyboard/controller MIDI OUT must be connected to the MULTIVERB ALPHA 2.0's
MIDI IN jack. The MIDI channel on the MULTIVERB ALPHA 2.0 must be set to the same
channel of the sending device, or the MULTIVERB ALPHA 2.0's OMNI mode must be ON.
-Make sure you are in EDIT Mode. (Press EDIT button if not)
-Press the MIDI button.
-Turn the Encoder until you see in the LCD:
MIDI PROG= 2 > MIDI PROG= 2
PRESET= 3_ > PRESET= 96_
-Select a patch on the keyboard or MIDI foot pedal so [MIDI PROG= 2] is displayed
(select either preset #1, 2 or 3). If the MPT has never been edited, [PRESET=
3_] should be in the lower half of the display.
*The patch that causes [MIDI PROG= 2] to appear in the display is usually the
second or third patch of the lowest numbered bank if the keyboard has banks of
patches.
-Use the Encoder to select preset 96.
-With the keyboard change the MIDI PROGram number to 3.
-Set the PRESET to = 1.
MIDI PROG= 3 > MIDI PROG= 3
PRESET= 4_ > PRESET= 1_
You may continue to program each of the keyboard's patches (say there are 64) in
this manner assigning any preset # to the patch.
In the previous examples four of the MPT entries were edited. You may edit the
entire MPT if desired.
INCREMENT PROGRAM
If you do not have access to a MIDI controller and you wish to change between
PRESETs easily, you may want to edit the MPT for incrementing through a sequence
of presets. Example 3 illustrates how this is done.
The sequence programmed in Example 3 may be accessed from the front panel. A more
useful way of using a programmed sequence is to access the sequence using the
REMOTE jack and a momentary footswitch. To access these presets we must program
the REMOTE JACK to increment the programs. You can only increment up through the
programs. Example 4 describes how program the REMOTE jack to sequence through the
ten presets set up in Example 3 with a footswitch. Example five shows how to
program the REMOTE jack for normal bypass operation.
EXAMPLE 3
Setting up a preset sequence including a bypass preset.
If you need to change between presets quickly without scanning or MIDI, this
procedure will be to your advantage. As in the other examples, editing the MPT is
the key. In this example we will edit the MPT to sequence through ten presets.
Ten is not the limit. You may program a sequence of 127 presets if you wish.
These presets will be in the order: 60, 151, 96, 1, 151, 35, 1, 69, 100 and 61.
Notice that we repeated some presets and included preset 100 which is set up from
the factory as a bypass preset (no effects stored in it). Remember you can assign