Specifications

30
STEREO-DDL-L
[STREO-DDL-L], [DDL]
Stereo Digital Delay - Long
Parameters:
:DLY-L=*
[250ms]
0 to 1300ms, increments:5ms;0-350, 10ms;350-700 20ms;700-1000,
50ms;1000-1300
:L-FINE* =
[0ms]
0 to 50 ms in 1 ms increments
:DLY-R* =
[125ms]
0 to 1300ms, increments:5ms;0-350, 10ms;350-700 20ms;700-1000,
50ms;1000-1300
:R-FINE* =
[0ms]
0 to 50ms in 1ms increments
:REGEN=
[45%]
0 to 100 percent in % increments
:HFDAMP=
[0%]
0 to 100 percent in % increments
:LEVEL=
[100%]
0 to 100 percent in % increments
*Total possible delay is 1350ms
You can split image or create alternating regenerative patterns between the left
and right outputs using Stereo Digital Delay. The ability to set separate delay
times for each channel enables you to do this. When used in conjunction with the
Flanger, Chorus or Panner, spatial effects are the result. Regeneration is
derived from the left channel.
When longer delay times are needed, use the STREO-DDL-L algorithm. Set both Left
and Right Delay times at 1300 ms for maximum delay output with no separation. You
may also operate this effect in mono.
SAMPLER-S
[SAMPLER-S], [SMP]
Sampler-Short
Parameters:
STAT=
[REC-RDY]
REC-RDY, PLAY, IDLE
RECORD=
[AUTO]
AUTO, MANUL, MIDI
PLAY=
[SINGLE]
SINGLE, PUNCHIN, MIDI, REPEAT, AUDIO
LENGTH=
[1.3s]
0.02 to 1.30 seconds in 20ms increments
START=
[5ms]
0 to 100ms in 1ms increments
LEVEL=
[100%]
0 to 100 percent in % increments
SAMPLER-L
[SAMPLER-L], SMP
Sampler-Long
Parameters:
STAT=
[REC-RDY]
REC-RDY, PLAY, IDLE
RECORD=
[AUTO]
AUTO, MANUL, MIDI
PLAY=
[SINGLE]
SINGLE, PUNCHIN, MIDI, REPEAT, AUDIO
LENGTH=
[1.58s]
0.02 to 1.58 seconds in 20ms increments
START=
[5ms]
0 to 100ms
LEVEL=
[100%]
0 to 100 percent in % increments