Specifications

17
OMNI Mode
ON, OFF [ON]
Sets MIDI OMNI mode on or off.
The MULTIVERB ALPHA 2.0 is shipped from the factory in OMNI mode, allowing it to
receive MIDI PROGRAM numbers on any MIDI channel.
MIDI Program Table
[PROG= #]
[PRESET= #]
Allows you to edit the Midi Program Table (MPT).
Refer to APPENDIX B for examples of editing the MPT and further documentation.
FX ON/OFF ENABLE (USING X-15)
ON, OFF [ON]
When the MULTIVERB ALPHA 2.0 is used with an ART X-15 ULTRAFOOT, the two devices
"talk" to each other. In order for the two devices to talk, Enable must be ON.
The ALPHA 2.0 enables commands to be received from the X-15 to turn the effects
in the preset on or off.
NOTES:
1) You must use two MIDI cables to communicate between the two units.
2) If you are not using the ALPHA 2.0 with an X-15, set the Enable to OFF.
'ENTER' TO EDIT ON/OFF CONTROLLERS
The purpose of being able to edit the ON/OFF controllers is to allow you to
change effect status without an X-15 ULTRAFOOT. You may also change the MIDI
controller number assigned to the effect.
Press the Enter button to set up the On/Off status of an effect in a preset. The
effect status defaults to On when you first add the effect to the preset.
If you edit the On/Off status
YOU MUST PRESS STORE TO SAVE YOUR CHANGES.
If you do not want an effect to be active instantly when a preset is recalled set
the Status to Off and press Store. When the preset is next selected, the effect
will be off. Access the EFFECT MODE of the X-15 and press the associated
activator pad to turn on the effect.
SWITCH # PAD STATUS * MIDI CONTROLLER
0 BYPASS OFF MC 84:MIDI CNTLR
1 EXCITER ON MC 70:MIDI CNTLR
2 COMPRESSOR ON MC 71:MIDI CNTLR
3 DISTORTION ON MC 72:MIDI CNTLR
4 EQUALIZER ON MC 73:MIDI CNTLR
5 EXPANDER/NOISE GATE ON MC 74:MIDI CNTLR
6 REVERB ON MC 75:MIDI CNTLR
7 DELAY ON MC 76:MIDI CNTLR
8 PITCH TRANSPOSER ON MC 77:MIDI CNTLR
9 FLANGE/CHORUS ON MC 78:MIDI CNTLR
10 SPECIAL EFFECTS ON MC 79:MIDI CNTLR
*The default status is On when the effect is selected.