Specifications

13
-Press the Value button and use the Encoder to select characters. If the Param
button is pressed, you may move the cursor left and right with the Encoder to
position it for the next character.
*Pressing the Value or Param buttons will move the cursor right or left one space
at a time.
-Press the Store button to save your title.
The title will appear in the upper half of the LCD and any selected effects are
in the lower half. If you wish to change the title, enter the Title Edit Mode and
make the appropriate changes. Don't forget to STORE the new title.
If there are characters you wish to delete in the display use the Encoder to move
the cursor and then press the ADD or DELETE EFFECT button. If you wish to delete
all sixteen characters press the DELETE EFFECT or ADD EFFECT buttons sixteen
times. By doing this you will eliminate any characters and have a blank display
to start with.
The ADD EFFECT button can be used to add spaces to the title, the DELETE EFFECT
button may be used to remove characters or spaces.
To exit or escape from the Title Edit mode, press the TITLE EDIT button once to
escape to EDIT Mode or press the EDIT MODE button.
NOTE:
When naming presets, try using descriptive titles relative to the preset.
What the preset does, what sounds it makes, or what to use the preset for all
will make preset selections easier to locate and use.
UTILITY
The Utility button allows you to access the user programmable utilities
available in the ALPHA 2.0 and view system information. Listed in this section is
information regarding the variable utility parameters with their default value
settings and ALPHA 2.0 system data.
To change Utilities, first enter Edit Mode then press the Utility button. Once
you are in Utility Mode you may change values by selecting the parameter and then
changing the value. To do this select the parameter you wish to modify with
either the Param or Value buttons. Use the Encoder to change the parameter value.
(Make sure the Value LED is lit)
To view system data, press the Param or Value button until the information you're
looking for appears in the display. Remember the Param and Value buttons act as a
left and right cursor when they are pressed repeatedly.
You do not need to press the STORE button to save Utility parameters, it is done
automatically when you exit Utility Mode.
To exit Utility Mode, press the Utility button to return to Edit Mode.
PROGRAMMING HINT:
Press the Value button to change and view the parameters then
use the Encoder to set the value. This way you don't have to switch between the
Param and Value buttons to edit values.