User`s guide

Here are some tips to help you with the initial set up:

1. Set channel levels to the center detent 0dB on the front panel.

2. Bypass the equalizer (Note: Select the bypass switch and press - the red LED is on.)

3. Set the frequency slide controls to the center detent or 0dB.

4. Select the 6dB range switch (green LED on).

5. Apply signal to the system.

6. Release the bypass switch, red LED off.

7. If the Clip LED is on you must turn down the input level control.

8.You may now start equalizing your system.

9. If you do not have enough gain for your needs, switch the range switch to the 12dB setting.

10. If the Clip LED lights continuously, turn down the level control until the LED is off most of the time.

FRONT PANEL CONTROLS

1. POWER SWITCH

To turn the equalizer ON or OFF, press the upper or lower portion of this button. CAUTION: Always

turn on your equalizer BEFORE your power amplifiers are turned on, and always turn off your equal-

izer AFTER your power amplifiers have been turned off.