User`s manual
10
4. Pulling out the short-circuit plug.the indicator
light turns flash. The rece iver get into working
mode.
1. Press the switch for frequency bind, then
turn on the transmitter's power.
5.
rebound.The transmitter get into working mode.
the indicator light will light.which means that the
radio system can work normally now.
Press frequency bind switch again to get it
3. If the frequency is successful, the
indicator light will light.
bind
2.
Receiver in the position of BATT.Connect the
ESC to receiver for electricity supply, wihch
results to the indicator light glitter.
Plug the short-circuit plug into the
Especial notice:
The process of
frequency binding for
this radio, please
follow the instruction
of this page.
!
The process of frequency bind for DSSS series 2.4GHz R/C system