Specifications
09
www.blitzrcworks.com
In C mode
1. Press the sub button to inter into the Swash menu (swash rate setting).
Figure 1 shows 120º CCPM while Figure 2 shows 90º CCPM.
2. Press the Y/UP or N/DOWN button to connect the aileron to channel 1 or
6, elevator to channel 2, and pitch to channel 6 or channel 1 (not occupied by
aileron).
A is for aileron, E for elevator, and R for rudder.
3. Press the left or right button to choose an option.
A is for aileron, E for elevator, and P for pitch.
4. Press the Y/UP button or N/DOWN button to increase or decrease the
setting value.
The value -100% to 100% indicates the actual output mixing rate.
Press the menu button to enter into the Cuv menu. There are 4 submenus
that include Thr, Pit, T3d, and P3d. Switch on the 3D and the 3D curve can be
activated.
Normal throttle settings:
1. Press the sub button to enter into the Thr menu (normal throttle curve
function).
2. Press the left or right button to choose a key point to set to.
5 key points corresponds to the channel trip of 0%, 25%, 50%, 75%, and 100%.
3. Press Y/UP or N/DOWN button to increase or reduce the value.
The value may be set to anywhere between 0% and 100%.
Normal pitch settings:
1. Press the sub button to enter into the Pit menu (normal throttle curve
function).
2. Press the left or right button to choose a key point to set to.
5 key points corresponds to the channel trip of 0%, 25%, 50%, 75%, and 100%.
3. Press Y/UP or N/DOWN button to increase or reduce the value.
The value may be set to anywhere between 0% and 100%.
3D throttle settings:
1. Press the sub button to enter into the T3d menu (3D pitch curve function).
2. Press the left or right button to choose a key point to set to.
5 key points corresponds to the channel trip of 0%, 25%, 50%, 75%, and 100%.
3. Press Y/UP or N/DOWN button to increase or reduce the value.
The value set takes effect when the 3D switch is turned on.
The value may be set to anywhere between 0% and 100%.
3D pitch settings:
1. Press the sub button to enter into the P3d menu (3D pitch curve function).
2. Press the left or right button to choose a key point to set to.
5 key points corresponds to the channel trip of 0%, 25%, 50%, 75%, and 100%.
3. Press Y/UP or N/DOWN button to increase or reduce the value.
The value set takes effect when the 3D switch is turned on.
The value may be set to anywhere between 0% and 100%.
4.CURVE SETTINGS