Specifications

The batteries are inspected separately. When the voltage reaches 4.20V, the charging
process stops.
Operating:
1. Then plug cigarette into its socket in car (Adapter should be connected if charge at
home: connect the adapter to home power socket, then plug the adapter' DC end to
charger). The LED will turn green indicating it is ready for charging.
2. Connect the battery to charger per its interface mark. The LED becomes red, which
means charging is on the way.
3. Adjust the current among 0.3A-1.0A. In order to prolong battery' life-span, we
recommend to charge them under low current if you have enough time.
4. When LED flashing, the charger will enter the stage of drip current charging. The LED
turns green when fully charged, and the battery will be used at any time.(Drip current
charging: Almost full and usable)
Notice:
1. Do not insert anything conductive into the cooling hole when power is on, or damage
will be caused to the charger.
2. While charging is in process, please do not place it near flammable materials.
3. It is not allowed to charge two-cell and three-cell Li poly battery at the same time.
4. Expect Li poly; this charger is not allowed for other kinds of battery.
5. While charging, please keep it out of the reach of Children.
6. When this charger is in use, please do not go away and leave it unwatched if any
abnormality occurs (such as the power indicator is off, the temperature of the battery rise
rapidly, etc.) stop charging immediately.
7. Please do not use power with output voltage higher than 15V.
8. Please do not disassemble the charger or its accessories.
9. When the battery is not cool down, please do not urge to charge it.
Safety Instructions for Li-poly batteries
01. Do not disassemble or reconstruct the battery.
02. Do not short-circuit the battery.