Installation & Assembly
Product Description and Measurements
DO NOT OVER TIGHTEN THE DRAIN !!!
Contact: 302-791-0447 or visit website at www.arsumo.com Copyright Arsumo USA
Thank You
Glass Vessel Sink and Waterfall Faucet Combo
Exclusive Arsumo Collcetion
For Above Counter Installation
Diameter: 14”-17”
Glass Thickness: 12mm-19mm
Waterfall Faucet
In Accordance with Industry Codes & Standards for USA & Canada
All Arsumo Glass Lavatory Sinks are Certied & Listed By cUPS
Arsumo would like to take this opportunity to thank you for this purchase. It is our hope that you are completely
satised with your new product. We welcome any questions or commnets that you may have and look forward
to assisting you with your accessory needs in the future.
Prior To Installation Steps
1. Unpack your new product and ensure that all the parts are included in the packing. keep the product in its
original box until you ready to install it.
2. The counter top must be at.
3. Shut o the water supply.
4. Observe all plumbing and duilding codes in your area.
5. It is recommended that installation of the product be done by a professional plumber.
Waterfall Faucet Installation
Please remember to turn o the hot and cold valves prior to installation.
STEP1 Check to see that your set contains the following parts:
- The faucet
- Hot and cold waterlines
- One rubber washer
- One brass washer
- Two mounting screws
STEP2 While holding the faucet facing you, locate the two larger openings at the base of the
facet.
STEP3 The left opening is for the hot water supply line and the right opening is for the cold
water supply line.
STEP4 Gently screw in the hot and the cold water lines. Make sure the waterlines are tightly
screwed in place.
STEP5 Insert the waterlines through the facet opening in the counter top and place the faucet
on the counter top. Make sure the faucet is facing forward and is aligned properly.
STEP6 From underneath the counter top, place the rubber washer rst so that it sits on top of
the metal washer. Be sure to align the openings on the washers with the openings on
the faucet.
STEP7 Tighten the brass nuts (located on the mounting screws) until the faucet is held tightly
in place.
STEP8 Connect the hot and cold water supply lines to the corresponding waters supply valves.