User`s manual

Page 32 · 4200-DR Series LaserSource User’s Manual
E-534 Po mode selected with
PD Response set to
zero
Attempted to select Po mode and PD Response
was zero, or LaserSource was in Po mode and
PD Response was set to zero.
E-535 Calibration cancelled The active calibration process was cancelled.
E-536 Intermittent contact
fault
The instrument detected an intermittent contact
and shut down the laser output. If this is
triggering falsely (such as in a noisy
environment), the intermittent contact detection
can be disabled in the main menu.
W-800 Remote voltage sense
is low
When in remote voltage sense mode, the
instrument detected a significant difference
between the remote voltage and the voltage at
the connector, which may indicate a problem with
the remote voltage sense connection.
E-998 Command not
supported
A command was recognized but not supported
by the instrument.
E-999 Non-specific error A non-specific error was encountered.