User`s manual

4200 Series LaserSource User’s Manual · Page 23
E-510 Laser out of tolerance
disabled output
The laser output was turned off because an
out-of-tolerance condition was detected and
the corresponding bit in the OUTOFF
register was set.
E-511 Laser control error
disabled output
A hardware control error was detected
which forced a shutdown of the laser
output.
E-512 Power failure A power failure was detected.
E-514 Laser mode change
disabled output
A change in the operating mode of the
LaserSource while the output was on
shutdown the output.
E-516 Incorrect
configuration for
calibration to start
The LaserSource was not configured
properly, including the mode and output on
state, to be able to start the desired
calibration process.
E-517 Calibration must have
the output on to start
The laser output must be on for the
calibration process to start.
E-534 Po mode selected
with PD Response set
to zero
Attempted to select Po mode and PD
Response was zero, or LaserSource was in
Po mode and PD Response was set to zero.
E-535 Calibration cancelled The active calibration process was
cancelled.
E-998 Command not
supported
A command was recognized but not
supported by the LaserSource.
E-999 Non-specific error A non-specific error was encountered.