5643166292

20
transmitter and model setup
Control throws
Aileron
Aileron
Rudder
Elevator
Elevator Rudder
Preflight check
After assembly and prior to your first flight, make sure all control surfaces respond correctly
to your transmitter by referring to the diagram below.
The suggested control throw setting for the Husky Special Edition are as follows (dual rate
setting):
1.Pull the tube from the clevis to the
linkage.
2.Carefully spread the clevis, then insert the clevis
pin into the desired hole in the control horn.
3.Move the tube to hold the clevis on the control
horn.
Tips: The maiden ight should always be own
using low rates, y the aircraft until you are famil-
iar with its characteristics prior to trying high rates.
Make sure the aircraft is ying at a decent altitude
and speed prior to using high rates, as the aircraft
will be sensitive to control inputs with the larger
control surface
movements.
High Rate
18mm up /down 14mm up /down
16mm up /down 12mm up /down
28mm left /right 20mm left /right
Low Rate
Clevis installation