User manual

Table Of Contents

Model assembly

Horizontal stabilizer installation

1.Align the horizontal stabilizer with the slot at the rear of the fuselage, and slide it towards the nose to tighten it.

2.Install the pushrod to the control horn on the horizontal stabilizer as shown.

Fuselage installation

1. Pass the servo extension cable through the front fuselage.

2. As shown in the ﬁgure, ﬁx the front and rear fuselage using the included screws.

(Note: please be sure that the front and rear fuselages are ﬁrmly connected before locking the screws)

HKM3.0*10mm

Landing gear set installation

2. Secure the main landing gear onto the fuselage with the included screws with the included retainer and screws as shown.

1. Align the landing gear with the slot on the bottom of the fuselage as shown, move the plastic block part out a lit to install

the front landing gear into the slot.

(Note: Check before installation to ensure that the landing gear wire is aligned with the hole position of the servo arm)