User Manual Prodigy RTF Motorglider with Vector Stabilization (1400mm)

05
Vector unit installation
1. Connect the servo wires of CH-1, CH-2, CH-4 to
Vector unit.
Model assembly
Horizontal stabilizer installation
1. Slide the horizontal stabilizer onto the vertical
stabilizer.
Linkage rod installation
1. Install the pushrod to the control horn on the
horizontal stabilizer as shown.
NOTE: Gently pull on the horizontal stabilizer to
ensure that the stabilizer has been properly installed.
2. Tear off the adhesive sticker on the back of Vector
unit and stick the Vector unit to the position as
shown in the below figure.
Note: the Vector unit should be parallel to the center-
line of the aircraft.