User Manual Prodigy RTF Motorglider with Vector Stabilization (1400mm)

Model assembly
04
Fuselage installation
1. Lead the two servo wires into front fuselage, and then
install rear fuselage to front fuselage as shown.
2. Secure the joint of the front and rear fuselage
using included screw.
HKM3.0*10mm
Main wing installation
1.Slide the wing spar into the pass through of fuselage
as shown
2.Apply the left and right wing halves onto wing spar,
pass the servo wires into fuselage and then have
them connected with a 2Y harness.
HKM3.0*10mm
3.Secure the wing set using included screws as
shown.