Instruction Manual Beginning Hawk Eye RTF (600mm) with Gyro Vector

User Manual
Functionality
Operation instructions
Power and calibration
1. This aircraft is equipped with Vector, an advanced flight control system. The two different flight modes (Stability and Dynamic)
can be toggled via the 2 position switch located on the left shoulder of the transmitter.
Stability mode: Allows for the aircraft to automatically level its wings when no user input is given. This mode is perfect for begin-
ners or as a safety function during loss of orientation.The aircraft will maintain level flight at half throttle, and slowly increase in
nose up attitude when the throttle is advanced above 50 percent.
Dynamic mode: Dynamic mode gives pilots full control over the aircraft without making any control inputs unless the attitude upset
is caused by factors such as wind gusts.
Binding
Connect the battery to the aircraft, turn on the transmitter and simultaneously press the two bind buttons to enter binding mode.
Transmitter warnings
1. After the transmitter is powered on, an audible signal is given every minute to assist the pilot in keeping track of flight time.The
green status LED indicates that the transmitter is operating normally.
2. When low on power, the transmitter will beep constantly and the status LED will turn red.
3. If the throttle stick isnt at 0 when the transmitter is powered on, the transmitter will beep constantly and the status LED will turn
red.
1.Transmitting power: less than or equal to 70mW
2.Transmission frequency: 2401 MHZ---2479 MHZ
3.Ground control range: greater than 300 meters
4.Transmitter power supply requirements: DC+6V (4 AAbatteries)
5.Receiver power supply requirements: DC+6V
1. Set the aircraft on a level surface, turn on the transmitter and then power on the aircraft.
2. Wait for the Vector system to self calibrate (rapid red LED flash).
3. After calibration (3 seconds), the aileron and elevator servos will cycle 3 times, indicating successful calibration.
4. Vector status LED:
Stability mode: LED flashes rapidly
Dynamic mode: LED stays on
Basic parameters
11