Instructions for use

The suggested control throw setting for the 50mm T-33 are as follows (dual rate setting):
Tips: The maiden flight should always be flown
using low rates, fly the aircraft until you are famil-
iar with its characteristics prior to trying high
rates. Make sure the aircraft is flying at a decent
altitude and speed prior to using high rates, as
the aircraft will be sensitive to control inputs with
the larger control surface movements.
Preflight check
Control horn and servo arm settings
transmitter and model setup
Control throws
After assembly and prior to your first flight, make sure all control surfaces respond correctly to your transmitter by refer-
ring to the diagram below.
07
10mm up / down
Elevator
Aileron 8mm up / down
8mm up / down10mm up / down
More control throw
Less control throw
Horns Arms
ElevatorAilerons
1. The table shows the factory settings for the
control horns and servo arms. Fly the aircraft at the
factory settings before making changes.
2. After flying, you may choose to adjust the linkage
positions for the desired control response.