Page1of15pages Report No.: 报告编号：KL20191220UA501 检验报告 TEST REPORT NAMEOFSAMPLE:Lithium-ion Battery Pack 产品名称：聚合物锂离子电池 CLIENT: Kiel Technology(Hong Kong)Limited 委托单位：奇奥科技（香港）有限公司 CLASSIFICATIONOFTEST: Commission test 检验类别：委托检测 广州邦禾检测技术有限公司 Guangzhou MCM Certification and Testing Co.
Report No.:KL20191220UA501 Page2of15pages UN 38.3 :2009/联合国专家委员会关于危险品的运输建议书 Applicant information 申请资料 Name of samples Lithium-ion Battery Pack 样品名称 聚合物锂离子电池 Type/Model 型号规格 AM-700995 3.7V 6000mAh 22.2Wh Trademark 商标 Commission by Kiel Technology(Hong Kong)Limited 委托单位 奇奥科技（香港）有限公司 Commissioner address Unit2111,Wayson Comm Bldg, 28 Connaguht Rd West, Sheung Wan, HK 委托单位地址 香港上環干諾道西 28 號威勝商業大廈 21 樓 2111 室 Manufacturer Xiamen AnRan Dynamic Electronic Co.
Report No.:KL20191220UA501 Page3of15pages UN 38.3 :2009/联合国专家委员会关于危险品的运输建议书 Test Conclusion 测试结论 No.
Report No.:KL20191220UA501 Page4of15pages UN 38.3 :2009/联合国专家委员会关于危险品的运输建议书 Photos of samples and markings 样品及标识照片 Battery（AM-700995 3.7V 6000mAh 22.
Report No.:KL20191220UA501 Page5of15pages UN 38.
Report No.:KL20191220UA501 UN 38.3 :2009/联合国专家委员会关于危险品的运输建议书 Page6of15pages Appendix 1 附表 1 Test Items 测试项目 1,1 Altitude simulation 高度模拟 Test procedure 测试步骤 Test cells and batteries shall be stored at a pressure of 11,6kPa or less for at least six hour at ambient temperature(20±5℃).
Report No.:KL20191220UA501 UN 38.
Report No.:KL20191220UA501 UN 38.
Report No.:KL20191220UA501 UN 38.
Report No.:KL20191220UA501 UN 38.
Report No.:KL20191220UA501 UN 38.3 :2009/联合国专家委员会关于危险品的运输建议书 Page11of15pages Appendix 6 附表 6 Test Items 测试项目 Crush 挤压 1,1 Test procedure 测试步骤 (a) (b) A cell or component cell is to be crushed between two flat surfaces.The crushing is to be gradual with a speed of approximately1,5cm/s at the first point of contact. The crushing is to be continued until the first of the three options below is reached.
Report No.:KL20191220UA501 UN 38.
Report No.:KL20191220UA501 UN 38.3 :2009/联合国专家委员会关于危险品的运输建议书 Page13of15pages Appendix 8 附表 8 Test Items 测试项目 Forced discharge 强制放电 1,1 Test procedure 测试步骤 Each cell shall be forced discharged at ambient temperature by connecting it in series With a 12V D.
Report No.:KL20191220UA501 Page14of15pages UN 38.3 :2009/联合国专家委员会关于危险品的运输建议书 Appendix 9 附表 9 Test Items 测试项目 Drop test 跌落测试 1,1 Test procedure 测试步骤 The package of batteries is dropped from1,2m in any orientation.The test floor is concrete floor.
Report No.:KL20191220UA501 Page15of15pages 注意事项 Important1. 1.本报告无检验单位公章、骑缝章无效； The test report is invalid without the official stamp and Paging seal of Guangzhou MCM Certification and Testing Co., Ltd. 2.未经本试验室书面同意，不得部分地复制本报告。 Nobody is allowed to photocopy or partly photocopy this test report without written permission of Guangzhou MCM Certification and Testing Co.,Ltd. 3.本报告无批准人、审核人及检测人签名无效。 The test report is invalid without the signatures of Approver, Checker and Tester. 4.
