Owner`s manual

9
Chime Mode
Your installer may have designated certain burglary zones to briefly activate the
mini-sounder contained in each keypad. These zones typically annunciate that
a door has been opened or closed while the panel was disarmed. To turn on
the chime operation, enter the following key sequence:
Figure 10
If chime operation is not desired, simply enter the following key sequence:
Figure 11
Fault Condition
A Fault Condition could, if unheeded, potentially render your system inactive.
If such a fault should occur it will be indicated by a flashing green READY light,
a TROUBLE message on the LCD display, and an audible warning tone at the
keypad.
To identify the nature of the Fault Condition, enter the following sequence. This
will also silence the audible warning:
Figure 12
Fault conditions will be displayed on the LCD display.
The LCD display will now indicate the nature of the problem and it will scroll
through the problems if there is more than one. Discuss with your installer what
action to take if a problem should occur. If a trouble condition occurs on a fire
zone,(or Day/Night Trouble Zone), call your installer for service as an important
part of your system is out of order. Other messages that you may see are listed
below.