Owner`s manual

The LCD display will be scrolling through the zones that were tripped.To exit

test mode enter your access code.

It is important for your safety that you test your system regularly.

Testing Communicator

Check with your installer as to how to test, and how often to test the

communicator portion of your system. Various central monitoring stations

have different procedures for testing the communicator. Your installer is

familiar with this procedure.

Smoke Detector Reset

If you have a smoke detector for use with your system, your panel can be

programmed to manually reset this device following an alarm condition by

simultaneously pressing the 1 KEY + 3 KEY on the SK1L keypad.

Abbreviated Arming

This allows the system to be armed by using only the first one, two, or three

digits of the access code. Once your installer has selected the number of digits

for abbreviated arming, access code(s) may be changed without effecting

abbreviated arming number of digits. All four access code digits must be used

to Disarm the the system.

Use full access code for arming if zone bypassing is desired.

Opening and Closing by User

The Opening and Closing by user code identifies the user who disarms

(opening) and arms (closing) the system. This is accomplished by assigning

an individual access code to each user, (up to 16 users on the SC800 and up

to 32 users on the SC1600). Select secondary codes as shown in Changing

User Code Section.