Owner`s manual

7
Figure 7
Instant/Delay Mode
The system will normally arm in the Delay Mode when leaving the premises.
This will delay arming, allowing time to exit. When entering, the alarm will be
delayed allowing time to disarm the system. The audible warning device will
sound during the entrance delay reminding you to disarm the system.
The Instant Mode is primarily used in residences. It is used during sleeping
hours when an entrance delay is not wanted. If the Instant Mode is desired,
enter the key sequence as follows:
Figure 8
The LCD display will show ARMED INSTANT .
Panel Test Mode
Your alarm system and its associated components (intrusion detectors, smoke
detectors, etc.) should be tested periodically. You can test these devices
yourself using the panel test mode. While in test mode the keypad beeps
continuously to tell you it is in test mode but it will not send any alarm signals
to the Monitoring Center. As you go through the system tripping the zones you
will get a short ring of the bell to let you know when a zone is violated. Entry and
exit delays are shortened to 4 secs during the test. After you have tripped all the
zones and returned to the keypad you will find all of the zones that responded
in ALARM MEMORY. In this way you can quickly test your system using only one
person and then verify that all zones worked when you return to the keypad.
If the Panel Test Mode is desired enter key sequence as follows:
Figure 9