Owner`s manual

(when ARMED light is on)

To Disarm your system (assume Access Code 1234), enter your Access

Code, key sequence as follows:

Figure 2

If you disarm your system, the armed light (RED) is off and the LCD display

will show READY if all zones are secure, or NOT READY if one or more zones

are not secure. If you silence the system after being in ALARM the LCD display

will show the zone description of the zone that was in alarm. This is called

ALARM MEMORY. It will be cleared the next time the system is ARMED. The

24 Hour zones will remain on all the time and they can be displayed by using

System Directory command code:

[Your Access Code] * 6 # .

--Green READY Light  when ON indicates that all protected areas

are secure and system is ready to be armed. A blinking ready light indicates

a Fault Condition.

--Red General ARMED Light  when ON indicates system is

armed or on. A blinking armed light indicates that an alarm has occurred.

--The "LCD DISPLAY" indicates system status in Alpha Numeric

characters, with zone arming, zone bypassing, alarms and trouble conditions

all being displayed.

System information such as AC OFF, LOW BATTERY, and FAIL TO COMMUNI-

CATE along with ZONE DESCRIPTIONS will be displayed when needed to

clearly show the current condition of the system.

NOTE: This manual will use the default descriptions when referring to the

LCDdisplay, and assume Auto Scrolling is enabled. These descriptions may be

changed by your installer.

Disarming & Silencing the System