Owner`s manual

9
Zone), call your installer for service as an important part of your system is out of order.
Other messages that you may see are listed below.
AC OFF: Indicates A.C. power to your alarm system has been disrupted.
LOW BATTERY: Indicates a low battery condition
FAIL COMMUNICATE: Indicates failure to communicate to the central monitoring
station.
IT IS IMPORTANT FOR YOUR SAFETY THAT YOU HAVE YOUR INSTALLER
CORRECT ANY FAULTS AS SOON AS POSSIBLE.
DURESS (AMBUSH)
Duress is used during a hold-up when youre ordered to disarm your system. When used,
a silent alarm is transmitted to the central monitoring station. Press the [9] key (or the
[0] key depending on how your system is programmed) after your Access Code, then
press the ENTER#. The system will disarm and a silent alarm will be transmitted.
NOTE: This function will only operate during a disarm command.
Normal Disarm Figure 14
✚
▲
#



■
4
●
1
●
32
ACCESS CODE
Duress Disarm Figure 15
◆
9
✚✚
▲
#
●
3



■
4
●
1 2
ACCESS CODE
EMERGENCY ALARM KEY PAIRS
There are four special emergency codes that can be initiated at the keypad. THESE
EMERGENCY ALARM KEY PAIRS MUST BE PRESSED SIMULTANEOUSLY, (a
feature designed to minimize false alarms). For example: Pressing the ENTER# first and
then pressing the STAR* key while the ENTER# is still held down will NOT send an
emergency signal. The special key pair combinations are marked with a circle, square,
diamond, or triangle.