Owner`s manual

18
2.37 INSTALLER PROGRAMMING
CALL DOWNLOADER COMPUTER
To have the panel call the “ScanPro Downloader” the following se-
quence is entered:
Figure 10
ANSWER THE DOWNLOADER COMPUTER
When the panel is programmed not to answer the telephone it may
be forced to answer the telephone by entering the following se-
quence:
Figure 11
SETTING SYSTEM’S TIME AND DATE (EKP1)
If it desired to change the date and time enter the key sequence as
follows:
Figure 12
There are a total of five parameters to be programmed in setting
the time and date of the system. These five parameters must be
programmed in consecutive order in the following steps and fash-
ion:
1. Enter the key sequence shown in Figure 11, the system will dis-
play the day of the week in numeric equivalence, i.e., a value of “1”
represents Sunday, “2” for Monday, and so on. Enter your correct
value for the current day of the week. In order to advance to the next
parameter, you must press the [Mode] key and proceed to the next
step.
2. The second parameter to be programmed is the month. Again,
this is displayed in its numeric equivalence, i.e. a value of “1” repre-
sents January, “2” for February, and so on. Enter your correct value
of the desired month and press the [Mode] key to advance.
3. The third parameter to be programmed is the day of the month.
Again, enter the desired value and press the [Mode] key to advance.
4. The fourth parameter to be programmed is the hour of the day.
This is displayed in 24-hour format. You must enter the hour, in (24-
hour) format, for the desired hour and press the [Mode] key to ad-
vance.
5. The fifth parameter to be programmed is the minute of the hour.
Enter the proper value and proceed to the next step.
6. After entering the last parameter, you must press the [ENTER]
key so that the new parameters will be set to the system. If for any
reason you do not want to program these new parameters, you
must wait 30 seconds without pressing any key, at which point the
system will abort the whole programming process.
NOTE: The display format for all the above parameters is identical to
the numeric display in the programming mode. The right bank of
LED’s that correspond to the zone numbers 1 through 8 are used to
indicate the unit digits of 1 through 8, a value of 9 is indicated by
lighting zones 1 and 8. Correspondingly, the left bank of LED’s are
used to indicate the tenth digits of 10 through 80, a value of 90 is
indicated by lighting zones 1 and 8 on the same bank.
NOTE:Do not use the [1 & 3] key sequence while setting the
clock. If a mistake is made, simply re-enter the data correctly
before pressing the Mode or Enter keys.
SETTING SYSTEM’S TIME AND DATE (EKP1L)
To set the time enter the keypad sequence shown in Figure 11.
1. The display will indicate [DAY MO-DD HH:MM] with the cursor
under DAY.
2. Use the numeric keys to enter the day of the week. 1= Sunday 2=
Monday and so on. Once you have the desired day press the right
arrow key to move the cursor to the next location.
3. Enter the month (1-12) and use the right arrow to move the cur-
sor.
4. Enter the day of the month (1-31) and use the right arrow to move
the cursor.
5. Enter the hour (0-23) and use the right arrow to move the cursor.
6. Enter the minute (1-59) and use the right arrow to move the
cursor.
7. The arrow keys can be used to move left or right to edit the values
until correct. When you have the correct value press enter to save
the data.