4x7 Yardsaver Assembly Manual

Step 7
 Parts Needed For 
Side/Rear Siding/Studs
 8074 Side Siding (2)
 8075 Rear Siding (1)
 8067 Siding Stud (3)
 8068 Siding Stud (2)
STEP
1 Position the side siding (6 board)
to corner posts,  at edge of siding
upward and bottom resting on 1st side
siding. See  gure. Always follow this
pattern. Fasten siding to corner posts
using six screws. Do not fasten  at
edge now. Position 2nd side siding
on opposite side of building and fas-
ten as before. Always use washers
where they are shown!
2 Repeat procedure with rear siding
panel. Fasten siding to rear header
to complete rear siding.
3 Position two short siding studs
between corner posts, behind side
eave frame, and fasten tab using
a screw. Rest bottom tab of stud
between siding and  oor frame and
fasten with a screw. Fasten siding
to studs, as shown.
4 Fasten one short siding stud to the
rear of building between the corner
posts in the same manner. Fasten
top tab behind rear header.
5 Position two long siding studs to
the left side of building in the same
manner using screws.
End View
STEP
1
Large hole in tab
8067
2
8068
8068
STEP
3
8067
8067
Bottom
Edge
Be certain all Siding
overlaps are fastened
with a single screw
8074
STEP
4
STEP
5
8075
Flat
Edge
Small hole in tab
Side Eave Frame
8074
Rear Header
22
AK22