Installation Guide

1 Fasten remaining top siding
(5 board), to the top side of building.
2 Fasten peak trim to peak of roof
using screws thru siding into frame.
3 Apply foil tape by overlapping
siding by 1/2" (13 mm), pressing firmly
into contour of siding, from top to
bottom of gables. Rub for good adhe-
sion. Do not cut tape, let roll hang
free until ready to use on next panel.
When complete, press opposite side
down to gable. The purpose of this is
to seal out the weather.
4 Apply foil tape to siding seam as
before. Fasten rear siding trim to
siding using screws.
5 Fasten right and left wall trim to
side corners of building using screws.
6 Fasten right and left roof trim to
the ends of roof, overlapping wall
trim, using screws.
7 Fasten right and left facia caps at
the breaks in the roof trim, using
screws.
8 Fasten bottom siding trim & top
siding trim to siding using screws.
9 Fasten trim cap to seam between
top and bottom trim using screws.
22
STEP
3
●●
●●
● 8432 Top Siding (2)
●●
●●
● 8439 Peak Trim (2)
●●
●●
● 8442 Rear Siding Trim (1)
●●
●●
● 8078 Right Wall Trim (1)
●●
●●
● 8079 Left Wall Trim (1)
●●
●●
● 8076 Right Roof Trim (1)
●●
●●
● 8077 Left Roof Trim (1)
●●
●●
● 8440 Bottom Siding Trim (1)
●●
●●
● 8441 Top Siding Trim (1)
● Parts Needed For ●
Top Siding/Trim
Step 9
BS22
8079
8077
8439
8440
FRONT
STEP
1
STEP
2
STEP
4
STEP
7
8439
Gable
Foil Tape
8432
8432
8442
Foil Tape
Under Trim
Facia
Cap
STEP
6
STEP
5
STEP
9
Trim
Cap
STEP
8
8078
8441
8076