Installation Guide

19
Step 6
BS19
● Parts Needed For ●
Side/Rear Siding/Studs
●●
●●
● 8431 Side Siding (4)
●●
●●
● 8075 Rear Siding (1)
●●
●●
● 8067 Siding Stud (5)
●●
●●
● 8068 Siding Stud (4)
1 Position the side siding (6 board)
to corner posts and stud, flat edge of
siding upward and bottom resting on
1st side siding. See figure. Always
follow this pattern. Fasten siding to
corner posts using screws and stud
using bolts and nuts. Do not fasten
flat edge now. Position 2nd side
siding on opposite side of building
and fasten as before. Always use
washers where they are shown!
2 Repeat procedure with rear sid-
ing panel. Fasten siding to rear
header to complete rear siding.
3 Position four short siding studs
between corner posts, behind side
eave frame, and fasten tab using a
screw. Rest bottom tab of stud be-
tween siding and floor frame and fas-
ten with a screw. Fasten siding to
studs, as shown.
4 Fasten one short siding stud to the
rear of building between the corner
posts in the same manner. Fasten
top tab behind rear header.
5 Position four long siding studs to
the left side of building in the same
manner using screws.
End
View
STEP
1
Large hole in tab
8067
8068
STEP
3
8067
Bottom
Edge
Be certain all Siding
overlaps are fastened
with a single screw
8431
STEP
5
8075
Flat
Edge
Small hole in tab
Side Eave Frame
STEP
4
STEP
2
Rear
Header
8431
8431
8431