Installation Guide

17
Step 4
BS17
● Parts Needed For ●
Corner Posts/Studs/Siding
●●
●●
● 6481 Gusset (4)
●●
●●
● 9793 Corner Post (2)
●●
●●
● 8433 Siding Stud (1)
●●
●●
● 8434 Siding Stud (1)
●●
●●
● 8431 Side Siding (4)
STEP
1 Attach a gusset to each end of the
two corner posts using one screw.
2 Fasten one corner post assem-
bly to the front corner of the floor
frame assembly using two screws.
Lightly fasten tab end of siding stud
to side floor frame using two screws.
Caution! Once corner post and stud
are attached, fasten one side siding
to the corner post and stud with fas-
teners shown. Repeat on rear of unit.
Do not fasten flat edge now.
3 Fasten remaining corner post, sid-
ing stud and two side siding panels
as in previous step.
IMPORTANT
Always use 2nd set of holes from
end of siding panel when attach-
ing to corner post or stud.
Remove
& Replace
8431
STEP
1
Corner Post
9793
2
6481
6481
STEP
3
9793
6481
6481
Side Siding
Trim
(Installed later)
TOP VIEW
FRONT
Siding Stud
8431
8431
8431
8433
8434
NOTE
For left end door location, fasten
siding studs as shown. For right
end door location, reverse
location of siding studs.