Installation Guide

●●
●●
● 9796 Ramp (1)
●●
●●
● 9795 Floor Frame (2)
●●
●●
● 8976 Side Floor Frame (4)
● Parts Needed For ●
Floor Frame Assembly
Step 2
BS15
The floor frame must be square
and level or holes will not align.
15
3 Assemble the four corners of the
floor frame using two screws at each
corner as shown.
4 Measure the floor frame diago-
nally. When the diagonal measure-
ments are equal, the floor frame is
square.
NOTE
If using a wood platform or
concrete slab do not fasten the
floor frames to your base at this
time. You will anchor the
building after it is erected.
STEP
8976
Level
STEP
4
When Diagonal Measurements
are Equal the Floor Frame
is Square.
1
Side Floor Frame
115 1/8" (292,4 cm)
8976
8976
1 Overlap the side floor frames as
shown. The holes in these pieces
will align when the pieces are posi-
tioned with correct amount of over-
lap. See the illustration below for the
proper overall length of the side floor
frames. Join the frames by inserting
five bolts and nuts in each frame set
as shown.
2 Center the ramp on top of the floor
frame. Note that the door can be
installed on either end. Join the
frames by inserting four screws.
8976
RIGHT
REAR
9795
2
STEP
STEP
3
9796
FRONT
9795
8976