Installation Guide

1 Position hinges on sides of right
and left door panels as shown and
fasten with 7/16" (11 mm) flat head
bolts outside and #6 hex nuts inside.
2 Slide foam board into door pan-
els, foil facing outward, equally
spaced on both sides. See caution.
3 Cover ends of door panel with
horizontal door brace. Edge of door
panel slides into brace. Fasten
braces to doors using two screws.
4 Using an awl, ice pick or nail, push
holes through foam board at the hasp
and staple holes. Attach hasp to
right door and swivel staple to left
door using 3/4" (19 mm) flat head
bolts and #6 hex nuts. Tighten nuts
through foam board using needle
nose pliers until they are against in-
side of door panel. Cover holes in
foam board panel with a piece of foil
tape.
5 Set the doors aside for later use.
Step 1
BR14
● Parts Needed For ●
Door Assembly
14
STEP
1
9794
STEP
4
●●
●●
● 9794 Horizontal Door Brace (4)
●●
●●
● 9788 Right Door (1)
●●
●●
● 9787 Left Door (1)
●●
●●
● 67729 Foam Board (2)
Hinge
Hinge
7/16" (11 mm)
Flat Head Bolt
#6-32x3/4" (19 mm) Flat Head Bolt
END VIEW
Hasp
#6 Hex Nut
Foil Tape
67729
Hasp
9788
CAUTION:
SHARP EDGE
9794
Foil Side
STEP
2
STEP
3
Screw
#6-32x3/4" (19 mm)
Flat Head Bolt
#6 Hex Nut
Foil Tape
Swivel Staple
END VIEW
Swivel Staple
9794
Foil Side
Hinge
Screw
67729
Hinge
7/16" (11 mm)
Flat Head Bolt
9787
9794