Installation Guide

 Parts Needed For 
Roof Panels
Step 18
STEP
STEP
3
BX33
 9491 Roof Panel (4)
1Position a roof panel overlapping
rib of left corner roof panel. Fasten
overlap at center of roof panel rib
using a bolt and nut. Fasten to roof
beams as done before using screws.
2Install a roof panel on the left side
of building. Repeat procedure with
2 more roof panels working side to
side. At the top beam end of panels,
fasten 2nd roof panel rib overlaps with
a bolt and nut.
3Cut the weather stripping tape
into 6 strips, each strip about 2" (5,1
cm) long. Press 2 strips over the
bolt heads on overlaps at the top of
panels. Save the other 4 strips for
the rest of roof.
4Cover the join at the peak with
weather stripping tape. Unroll the
tape and press it down over the
opening at the ridge as you install
each roof panel. Do not cut the tape
at this time.
STEP
1
ROOF PANEL
SCREWS TO ROOF BEAM
SLOTTED
HOLES AT
TOP
FASTEN
AT
OVERLAP
FIRST
SCREWS TO
ROOF BEAM
SMALL
HOLES
AT BOTTOM
Weather Stripping Tape
9491
Crimped Rib is Always Overlapped
by Wide Rib of Adjacent Panel
Weather
Stripping
Tape
4
STEP
2
NOTE
On the 14x31 (4,2 m x 9,4 m),
cut the weather stripping tape
into 10 strips.
Follow Fastener Sequence
33