Installation Guide

 Roof Beam Assembly (8)
 Left Gable Assembly (2)
 Right Gable Assembly (1)
 9462 Roof Beam Assembly (5 14x31: 4,2 m x 9,4 m)
 Parts Needed For 
Gables/Roof Beams
Step 14
STEP
1
STEP
STEP
2
3
BX29
1Lift and fasten a left gable assembly
in the same manner.
2Join the left and right gables
together using a bolt and nut in the
third hole from the bottom only.
3Apply the weather stripping along
the mating edge of the left and right
gables as shown. Cut the weather
stripping to length.
4Install roof beam assemblies to
the left side of building in the same
manner. Slide a roof beam assembly
over center gable fl ange and other
end over shear plates on truss and
fasten as before.
Repeat roof beam procedure for the
opposite end of building. Note that 4
hole cluster in roof beam assembly,
must be fastened toward truss.
STEP
4
NOTE
On the 14x31 (4,2 m x 9,4 m),
attach the roof beams between
the truss assemblies as before
14x21
(4,2 m x 6,5 m)
Weather
Stripping
Tape
4 holes toward truss
9462
29
14x31
(4,2 m x 9,4 m)