Installation Guide

Each wall panel has a crimped rib
on 1 side. The crimped rib should
go under the rib of the panel that
follows it.
1 Fasten the wall panels at the top
and bottom with screws.
2 Fasten the center of each panel to
the wall channel with screws. Fasten
overlapping ribs using screws and
bolts with nuts.
3 When you have attached all wall
panels in the correct positions, the
building will look like this.
4 Fasten right and left track
supports to the front columns using 5
bolts from the inside and nuts outside.
NOTE
Flanges on track supports must
face towards front of building.
Step 11
BX26
 Parts Needed For 
Walls Panels/Track Supports
 9470 Wall Panel (17 14x21: 4,2 m x 6,5 m)
(8 14x31: 4,2 m x 9,4 m)
 10458 Right Track Support (1)
 10459 Left Track Support (1)
STEP
3
STEP
1
9470
STEP
2
STEP
4
10458
10459
10459
INSIDE
BUILDING
Bolt and nut
does not go
thru wall channel
at overlap
Detail Showing
Center of Panel Screwed
to Wall Channel
Crimped Rib
Underneath
26