Installation Guide

NOTE
The remainder of the building
assembly requires many hours
and more than one person. Tie
down and support assembly
before the end of the work day.
A partially assembled building
can be severely damaged by
light winds.
Each screw and bolt in the wall
requires a washer.
1 Position a corner panel at the
corner of the fl oor frame as shown.
The widest part of each corner panel
must be placed along the side of the
building for all 4 corners. Fasten the
corner panel to the fl oor frame with
4 screws.
Support the corner panel with a step
ladder until a wall panel is attached.
2 Attach the front wall panels to
the front corner panels, as shown.
3 Attach the wall panels to the rear
corner panels, as shown.
NOTE
Be careful to install the correct
panel in each position as shown.
4 Double-check the part numbers of
the wall panels, before proceeding.
Step 6
BX21
 Parts Needed For 
Corners
 9471 Wall Panel (2)
 9473 Front Wall Panel (2)
 9472 Corner Panel (4)
The fl oor frame must be square
and level or holes will not align.
Washer
STEP
4
STEP
2
STEP
3
9473
9473
SIDE
SIDE
REAR
FRONT
9472
Narrow
Side
STEP
1
Wide Side
TOP VIEW
9473
9472
9472
9472
9471
9471
Crimped Rib
Underneath
9472
9471
9472
9471
9473
9472
9472
21