Installation Guide

 Parts Needed For 
Trim 12x17, 12x24 & 12x31
Step 26
BW37
 5220 Side Roof Trim (see below)
 6014 Side Roof Trim (2)
 7845 Left Rack (2)
 7846 Right Rake (2)
STEP
6
STEP
2
STEP
1
STEP
4
STEP
3
1Attach the side roof trim to the
lower end of the roof panels on each
side of the building using screws at
each panel overlap.
NOTE
A single screw fastens both trim
pieces at the overlap.
2Position left and right rake to the
ends of roof, noting that rake slips
under ridge cap, but fi ts on top of side
roof trim. Fasten rake to the center
of roof panel rib using a bolt.
3Fasten roof panel rib, rake, peak
cap and ridge cap together using bolts
and nuts. Fasten remaining peak cap
in the same manner.
4Using your thumb and index fi nger,
overbend the bottom fl ange of the side
roof trim at the corner inward enough
so the right and left roof trim caps fi t
onto right and left corners.
5Fasten rake to side trim using a
screw into roof panel.
6Fasten the roof trim caps to the side
trim using a screw.
IF YOU ARE BUILDING A 12x24 (3,6 m x 7,2 m)
Install additional side roof trim 5220 towards rear
of building.
IF YOU ARE BUILDING A 12x31 (3,6 m x 9,4 m)
Install 2 additional side roof trim 5220 pieces
towards rear of building.
STEP
5
(3,6 m x 5,0 m / 3,6 m x 7,2 m / 3,6 m x 9,4 m)
#8Ax5/16" (8 mm) Screw
#10-32 Square Nut
Peak Cap
Roof Trim Cap
7846
7845
6014
5220
5220
#8Ax5/16" (8 mm) Screw
Tuck Flange In-
ward to Fit Inside
of Roof Trim Cap
#10-32x7/16" (11 mm) Bolt
37