Installation Guide

 Parts Needed For 
Ridge Caps 12x17, 12x24 & 12x31
Step 24
BW35
 7828 Middle Roof Panel (see below)
 7843 Ridge Cap (see below)
 7827 Left Roof Panel (1)
 6874 Ridge Cap (1)
8
STEP
STEP
IF YOU ARE BUILDING A 12x24 (3,6 m x 7,2 m)
Replace ridge cap 6874 with an additional
ridge cap 7843 and install ridge cap 6874 to
rear of building.
IF YOU ARE BUILDING A 12x31 (3,6 m x 9,4 m)
Replace ridge cap 6874 with 2 additional ridge
caps 7843 and install ridge cap 6874 to rear
of building.
1Continue weather stripping and
fastening overlaps.
2Position a ridge cap 7843 on the
completed front roof section.
3Install 2 middle roof panels.
4Install the second ridge cap 7843
overlapping the fi rst ridge cap. Align
the holes and fasten using bolts.
5Temporarily remove right rear roof
panel. Install 4 middle roof panels.
As each panel is fastened, carefully
raise 2nd ridge cap slightly away from
panels for fasteners and tape.
6Install the right and left roof
panels at the rear gables. Follow
fastener sequence.
7Install the third ridge cap 6874
overlapping the second ridge cap.
Align the holes and fasten using
bolts.
8Fasten the lower end of the
panels to the side top angle using
screws.
3
STEP
6
STEP
1
STEP
4
STEP
2
STEP
7
STEP
5
(3,6 m x 5,0 m / 3,6 m x 7,2 m / 3,6 m x 9,4 m)
Do not fasten
this end
Do not fasten
this end
6874
Weather Stripping
#10-32x7/16"
(11 mm) Bolt
7843
Weather Stripping
#8Ax5/16" (8 mm) Screw
#10-32 Square Nut
7828
7827
7843
35