Installation Guide

The mid frame pieces give rigidity to
the side and rear wall.
NOTE
Before installing mid frames de-
cide at which location you
want the entrance door. Do not
install the 1x2 (2,5 x 5,1 cm) mid
frame at 1 of 3 locations.
1 Fasten a rear frame assembly to
the main wall panels using screws.
2 Fasten a right and left front frame
to the front wall panels the same way.
3 Attach 4 frame supports to the
middle of the 2 truss columns using
2 bolts and nuts on each.
4 Fasten side frame 7914 to the rear
corner panel using screws. Be sure
set of holes 1" (2,5 cm) in from end
of frame is installed toward rear of
building. Where rear frame overlaps
side frame in corner, fasten using 2
bolts and nuts. Fasten opposite end
to frame support on truss column, us-
ing 2 bolts and nuts in the 1st set of
holes. Fasten truss support to truss
column at bottom with 1screw at the
1st hole on column. Support column
assembly with step ladder.
Step 8
BW20
 7914 Side Frame (see below)
 7837 Side Frame (2)
 6228 Frame Support (4)
 7949 Side Wall Channel (1)
 7951 Support Column (1)
#10-32 Square Nut
STEP
4
STEP
2
STEP
3
STEP
1
5 Fasten side frame 7837 to the front
corner panel using screws. Fasten
overlap in corner. Fasten opposite
end to the frame support on truss
column, using 2nd set of holes. This
will leave a gap between side frame
and truss column.
STEP
6
For a 12x24 (3,6 m x 7,2
m) building repeat column
procedure here
 Rear Frame Assembly (1)
 7834 Right Front Frame (1)
 7835 Left Front Frame (1)
 7917 Truss Column (see below)
STEP
5
STEP
7
#8Ax5/16" (8 mm) Screw
7837
7835
7834
#10-32x7/16"
(11 mm) Bolt
7917
7949
8531
7951
8532
7914
SIDE
REAR
GAP
1st HOLE
ON COLUMN
7837
7914
1st SET
OF HOLES
2nd SET
OF HOLES
6228
7917
7837
FRONT OF BUILDING
6 Fasten side wall channel to the
rear corner panel using screws.
7 Fasten support column to side
frame and side wall channel using
bolts and nuts where shown. Fold
corner panel slightly away from
column to fasten bolts from outside.
See Step 12 for rear door installation.
IF YOU ARE BUILDING A 12x24
(3,6 m x 7,2 m)
Each side of building will have 2 column
assemblies and 2 extra side frames 7914.
IF YOU ARE BUILDING A 12x31
(3,6 m x 9,4 m)
Each side of building will have 3 column
assemblies and 4 extra side frames 7914.
GAP
Support this truss column with a
step ladder until next step
 Parts Needed For 
Frames
12x17, 12x24 & 12x31
(3,6 m x 5,0 m / 3,6 m x 7,2 m / 3,6 m x 9,4 m)
1"
2,5 cm
20