Installation Guide

The gables go on top of the front and
rear walls to support the roof beams.
The gables are packed nested to-
gether and might be mistaken as
1 piece. Carefully separate them
before continuing.
1 Position mid and outer gable
braces on right and left gables.
Short mounting fl ange of brace must
face center of gable. Fasten using
#10-32x7/16" (11 mm) bolts, washers
and square nuts. Assemble 2 sets
of gables.
Step 2
BW15
 Parts Needed For 
Gables All Sizes
 6381 Mid Gable Brace (4)
 6380 Outer Gable Brace (4)
 7942 Right Gable (2)
 7943 Left Gable (2)
7912
#10-32 Square Nut
#10-32x7/16" (11 mm) Bolt
10462
Short Mounting Flange
Must Face Towards
Center of Gable
Step 3
 Parts Needed For 
Roof Beam Assemblies
 10462 Roof Beam (2) (All Sizes)
 7912 Roof Beam
(2) 12x17 (3,6 m x 5,0 m)
(4) 12x24 (3,6 m x 7,2 m)
 (6) 12x31 (3,6 m x 9,4 m)
The roof beams join the gables to the
truss and supports the roof panels.
1Align the holes on 2 roof beams,
back-to-back and fasten using 4
#10-32x7/16" (11 mm) bolts and
square nuts.
Small Holes
on Top
7942
7943
6380
6381
#10-32x7/16" (11 mm) Bolt
#10-32 Square Nut
Washer
FRONT
Assembled
End
View
15