Operating instructions

9. Insert the threaded screw of each knurled knob through the bearing
flange and carrier block and screw it into the mounting flange, but do
not tighten.
10. Notice that the carrier blocks are flat on one edge. The carrier blocks
should be rotated so that the flat edge faces forward, mid-way between
the front panels of the Remote Control Unit and Auto Locator. Refer to
Figure 2-6 or 2-7. Tighten the knurled knobs.
NOTE: In both illustrations, the carrier block orientation is the same. The flat
side is up, and the thinner flange faces the V-bracket.
11. Attach the carrier block to either the mounting rails for desk-top use
(Figure 2-6) or the optional roll-around stand (Figure 2-7).
A. Use 4 flat-head phillips screws to attach each of the two rails to the
block as shown in Figure 2-6.
B. First fasten the U-bracket to the upright member of the roll-around
stand using 3 oval head phillips screws. Then use 2 cap-head allen
screws to attach each carrier block to the U-bracket as shown in
Figure 2-6. The combined Remote Control Unit/Auto Locator/U-
bracket/upright assembly can now be inserted in the roll-around
base.
12. The Remote Control Unit/Auto Locator assembly can be tilted to any
working angle by loosening the knurled knobs, and the locking in place
by tightening the knobs.
Figure 2-6
Desk Top Stand Assembly
Figure 2-7
Roll-Around Stand Assembly
Section 2 Installation
2 - 8
October 1990
MTR-90III Operation and Maintenance Manual