Operating instructions

2.3 Stand Assembly (for Remote Control Unit and Auto Locator)
Refer to Figure 2-5 for the following instructions.
1. Remove the four pieces on the side of the Remote Control Unit.
2. Place the CB-147 Remote Control Unit panel upright on a flat work
surface. Connectors should be facing away.
3. Locate the two large aluminum V-brackets. Using 3 allen head cap
screws per bracket, attach one V-bracket to each side of the Remote
Control Unit.
NOTE: While the brackets are nearly identical, each has the matte finish on
different sides. The shiny side of each bracket should rest against the
Remote Control Unit, and the leg of the bracket with 2 large holes (not 3)
should be attached to the Remote Control Unit.
Figure 2-5
Assembling Auto Locator and Remote Control Unit
4. Locate the 4 brass flanges. Attach the 2 larger mounting flanges to the
middle of the two V-brackets (on the matte side) using 3 flat head
phillips screws per flange.
5. Set the CB-148 Auto Locator directly on top of the Remote Control Unit
between the V-brackets to which it will be secured. Lift the Auto Locator
up slightly so that the middle screw hole in the remaining leg of each V-
bracket aligns with the corresponding hole in the Auto Locator. Insert
one allen head cap screw into each of these holes and partially tighten.
6. Pivot the Auto Locator so that the remaining two screw holes in each
bracket align with the holes in the Auto Locator and insert two more
allen head cap screws per bracket. Then tighten all the allen head screws
to secure the Auto Locator to the bracket.
7. Examine the 2 identical square black carrier blocks. Notice that one side
of the part is labeled “A” near the center, and the other “B.” Press the
blocks onto the mounting flanges of the V-brackets so the “A” side of
each block is adjacent to the V-bracket.
8. Insert the remaining brass bearing flanges in each of the carrier blocks.
NOTE: THE THIN EDGE OF THE
CARRIER BLOCK FACES THE REMOTE
CONTROL UNIT. THE FLAT SIDE OF
THE BLOCK FACES THE JUNCTION OF
THE FRONT PANELS OF THE TWO
BOXES. THE SAME BLOCK POSITION
IS USED FOR BOTH DESK TOP AND
ROLL AROUND STANDS.
REMOTE CONTROL UNIT
AUTO LOCATOR
MTR-90III Operation and Maintenance Manual
October 1990
Section 2 Installation
2 - 7