Operating instructions

2.2 Assembly of Remote Control Unit
The Remote Control Unit is provided with a stand for desk top use. The
Remote Control Unit can be fitted with the angle adjusting knob for use at
any convenient position. Refer to Figures 2-3 and 2-4.
❑ Attaching the ZA-52J Stand Assembly
1. Remove the two sections of the stand.
2. Assemble the ZA-52J Stand Assembly (Figures 2-3 and 2-4).
3. Put the Remote Control Unit gently on the fitting arm and attach the Unit
to the arm with the four screws provided.
4. Loosen the knob to adjust the angle. When at the desired angle,
retighten the knob to hold the Remote Control Unit secure.
NOTE: THE THICK EDGE OF THE CARRIER
BLOCK FACES THE REMOTE CONTROL BOX,. THE
FLAT EDGE OF THE BLOCK FACES DOWN.
Figure 2-3
Assembling the Mounting Flanges
NOTE: THE THICK EDGE OF THE CARRIER
BLOCK FACES THE REMOTE CONTROL BOX,.
THE FLAT EDGE OF THE BLOCK FACES UP.
Figure 2-4
Attaching the Stand Assembly
Section 2 Installation
2 - 6
October 1990
MTR-90III Operation and Maintenance Manual