Installation Guide

1 Install two roof panels, left roof
panel, three ridge caps 6797 and
right roof panel on the front of the
roof as before.
2 Fasten the roof panel ribs, peak
caps and ridge caps together using
bolts and nuts.
3 Fasten the lower end of the panels
to the side wall angles using screws
and washers.
Reducing Large Gable Bulge
Loosen eight bolts and nuts shown.
Apply pressure with one hand at the
peak of the gable and tighten bolt #1.
Keeping pressure on the gable work
down the slope tightening each bolt.
Excess material will overlap smaller
gable at seam. Once material bulge
is worked out tighten four vertical bolts
that connect the large and small gables.
 7861 Roof Panel (2)
 7863 Left Roof Panel (1)
 6797 Ridge Cap (3)
 7862 Right Roof Panel (1)
Step 17
ST30
 Parts Needed For 
Roof Assembly
STEP
1
7862
STEP
7863
STEP
2
3
6797
7861
Cut
Weather Stripping
and Fold Under
6797
7861
#1
#2
#3
#4
6797
Peak Cap
30