Installation Guide

Each screw in the wall requires a
washer.
1 Slide side siding (5 board) into
channels of corner and splice posts,
fl at edge upward, slotted edge down
resting on fl oor frame. Always fol-
low this pattern. Fasten lower edge
and tab of stud to fl oor frame using
screws. Fasten center to stud with
screws. Do not fasten top edge yet.
2 Install side siding (5 board) as
before. Note how the slot in lower
edge must overlap fl at edge of last
siding. Fasten both siding panels to
stud at this overlap.
3 Install side siding (5 board) to the
top as before. Remove and reuse
screw in angle to fasten top siding.
4 From inside building, fasten siding
to corner posts and splice post using
screws.
5 Install rear siding and front siding
as before. Note that the front siding
is only fastened from inside.
NOTE
Be careful to install the correct
panel in each position as shown.
The fl oor frame must be square
and level or holes will not align.
 9193 Side Siding (5 board) (12)
 8736 Rear Siding (5 board) (6)
 8737 Front Siding (5 board) (6)
 Parts Needed For 
Side/Rear/Front Siding
Step 10
SS23
STEP
3
1
STEP
4
STEP
2
(5 board)
(5 board)
Siding Chart
Front Siding Side Siding Rear Siding
(5 board) (5 board) (5 board)
8737 9193 8736
STEP
Washer
(5 board)
(5 board)
(5 board)
(5 board)
Fasten Top
Center of Last
Siding to Stud
Fasten Siding
to Corner & Splice
Posts From Inside
CORRECT
INCORRECT
23