Instructions / Assembly

Step 3
BO12
● Parts Needed For ●
Mounting Rear Roof
Channel to Structure
12
●●
●●
● Rear Roof Channel Assembly (one)
● ●
● ●
● 66627 Weather Seal
1/2x 1 1/2 (13 mm x 3,8 cm) (one)
9665
Level
9734
9665
Concrete
Rear Roof Channel Assembly
END VIEW
Post
8'-8 1/2" (265,4 cm) Min.
9' (274,3 cm) Max.
1 Positioning The height from the bottom of post to the bottom of rear roof channel is 8'-8 1/2" (265,4
cm) minimum to 9' (274,3 cm) maximum. For unit installed over a door, in order to maintain door clearance, the
minimum height above door is 6" (15,2 cm). If distance is less than 8'-8 1/2" (265,4 cm), bottom of posts will have
to be trimmed (with hacksaw) in order to obtain 2 1/2" (6,4 cm) slope. If this is necessary, drill two new holes in
post and re-attach anchor. For installation where a door is not involved, do not block windows with rear roof
channels. Once dimensions are established, level rear roof channels and mark structure.
2 Channel Weather Stripping Attach weather stripping 1/2x 1 1/2 (13 mm x 3,8 cm) to one
end, on the outside of rear roof channel. Making sure weather stripping is flush with top flange of rear roof
channel, continue to stick weather stripping to rear roof channels. Peel paper backing.
1/2x1 1/2 (13 mm x 3,8 cm)
Weather Seal
6" (15,2 cm) Min.