Installation Guide

1 Position the rear corner panels
at the rear corners, as shown. The
widest part of each rear corner panel
must be placed along the rear of the
building. Attach the corner panels to
the fl oor frame with four screws.
2 Position a front corner panel
at the corner of the fl oor frame as
shown. The widest part of each front
corner panel must be placed along
the front of the building. A small gap
will exist between front corner panel
and ramp. Fasten the corner panel
to the fl oor frame with three screws.
NOTE
Be careful to install the correct
panel in each position as shown
NOTE
The remainder of the building assembly
requires many hours and more than one
person. Do not continue beyond this
point if you do not have enough time to
complete the assembly today. A partially
assembled building can be severely
damaged by light winds.
Each screw and bolt in the wall
requires a washer.
3 Double-check the part numbers of
the wall panels, before proceeding.
The fl oor frame must be square
and level or holes will not align.
FRONT
STEP
TOP VIEW
9384
SIDE
REAR
Wide
Side
9380
SIDE
Narrow Side
9384
2
9380
STEP
1
Washer
Panels rest on
frame as shown
9380
9384
9384
9380
STEP
3
(14)
CORRECT
INCORRECT
19
 9380 Front Corner Panel (2)
 9384 Rear Corner Panel (2)
 Parts Needed For 
Corners
Step 6
B19 ctr