Installation Guide

37
• Bolts under Ridge Cap pass thru
slots where the End Roof Panel is
overlapped by the Panel next to it
(labeled rib 2 below).
(QTY: 16)
Roof Panel
2
5209
(QTY: 16)
Continue to apply weather stripping.
Step 14: Continued
Attach End Panels to the Roof Panel next to
it using three (3) bolts and nuts each. Place a
strip of tape over each bolt to seal. Cover the
notches on Roof Panels with strips of weather stripping
tape.
4
6
Install Roof Panels #9 and #10. Cover the
notches on Roof Panels with strips of weather
stripping tape.
5
Attach Long Ridge Caps with two (2) bolts and
nuts. DO NOT secure end of Ridge Caps until
Peak Caps are in place.
DO NOT secure end of Ridge Caps
until Peak Caps are in place.
Place strips of tape
over bolts to seal.
You will need for this page:
Ridge Cap
3
8840
1
2
3
4
5
• Bolts thru Ridge Cap pass thru slots where the
Center Roof Panel overlaps the Panel next to it
(labeled rib 5 below).
DO NOT fully tighten Ridge Cap bolts until you
have both Ridge Cap bolts in place. This will ease
assembly. Bolts must be fully tightened before moving on
to the next page.
37BI