Manualshelf

Installation Guide

ManualsBrandsArrow ManualsMetal Storage Sheds(Common: 10-ft x 8-ft; Interior Dimensions: 9.8500-ft x 7.5000-ft) Galvanized Steel Storage Shed
31323334353637383940
36
Roof Panel
2
5209
Roof Panel
2
6538
Attach Panels #5 - #8 according to the diagram on page 34.
Weather stripping tape should be applied in one
continuous strip along the length of the roof.
You will need for this page:
(QTY: 4)
(QTY: 32)
Step 14: Roof Assembly
Cut thirty-six (36) strips of weather stripping 3”
(7,5 cm) long from the roll of weather stripping
tape and put aside for later use. Begin weather
stripping the roof ridge. Apply more of the weather
stripping after each additional Panel is installed.
1
3
Do not fasten the holes on the lower end of the
Panels. Do not install Panels #9 or #10 yet.
Double check that Panels are installed in the
correct position. The part numbers listed in the Roof
Panel Placement diagram on page 34 must match the
numbers inked on the Panels.
2
Attach Panels #5 - #8 in the order given in the
diagram on page 34. Use the diagram to the
right while assembling the roof.
5209
5209
6538
6538
36BI
DO NOT FASTEN AT THIS TIME
FASTEN TO NEXT PANEL WITH BOLT AND NUT
FASTEN TO ROOF BEAMS WITH SCREWS
FASTEN TO RIDGE CAP (NEXT PAGES)
FASTEN TO RIDGE CAP (NEXT PAGES)