Installation Guide

24
Side Wall Angle Assembly
Side Wall Angle Assembly
Rear Wall Angle Assembly
Door Track Assembly
Leave these holes open.
ATTACH FRAMES TO INSIDE OF WALL PANELS
Assemblies from Step 2 and Step 4:
• Rear Wall Angle Assembly (1)
• Side Wall Angle Assemblies (2)
• Door Track Assembly (1)
(QTY: 18)
Wall Angles must face
inside the building.
You will need for this page:
Door Slides should be in Door Track at this time.
Step 7: Wall Framing
2
Use the number of screws shown. Leave the hole
closest to the Ramp open in each Front Panel as
shown above.
• Install one Side Wall Angle Assembly fi rst.
• Install the Rear Wall Angle Assembly second.
• Install the other Side Wall Angle Assembly third.
• Install the Door Track Assembly last.
1
Short Leg on Bottom.
Opening Faces In.
Long Leg on Top.
24A