Installation Guide

Step 17
SO30 ctr
 Parts Needed For 
Ridge Caps & Panels
 6538 Roof Panel (2)
 6797 Ridge Cap (3)
6188 Right Roof Panel (1)
6189 Left Roof Panel (1)
1 Install the third ridge caps 6797
overlapping the second ridge caps
while installing the remaining roof
panels 6538. Hint: The bolts on the
ridge cap need to be left loose to
move the ridge cap to the side and
overlap the ribs of the next roof panel.
Cover the notched areas of the roof
panels with strips of weather stripping
tape and continue weather stripping
the ridge.
2 Install the left 6189 and right roof
panel 6188 as you unroll the weather
stripping tape, and press it down.
Fasten the lower end of the panels
to the side wall angles using screws
and washers.
3 Fasten the roof panel ribs, peak
caps and ridge caps together using
bolts and nuts.
Reducing Large Gable Bulge
Loosen eight bolts and nuts shown. Apply
pressure with one hand at the peak of the
gable and tighten bolt #1. Keeping pressure
on the gable work down the slope tighten-
ing each bolt. Excess material will overlap
smaller gable at seam. Once material bulge
is worked out tighten four vertical bolts that
connect the large and small gables.
Peak Cap
STEP
2
6797
STEP
2
6797
6188
STEP
3
STEP
1
Cut
Weather Stripping
and Fold Under
6189
6538
6538
6797
#1
#2
#3
#4
(72)
(36)
30